Bosch rexroth IndraControl VAC 08.1, Operating Instructions Manual

Page: 31 / 40

SEL MOD Operator display 1 (XCDI+tx1) Operator display 2 (XCDI+tx1)
0 1 Active Active
1 1 - -
0 Open or 0 V
1 24 V
Tab. 12-1: The operation modes are selected using the inputs "SEL" and "MOD"
12.2 Display elements
There are five LEDs on the CDI+ splitter (see fig. 9-1 "Connector panel of the
CDI+ splitter" on page 12 ). The LEDs indicate the current operating state.
LED Description
Vin Display of the 24 V voltage supply
Video1
Link1 Operating state, operator display 1
Video2
Link2 Operating state, operator display 2
Tab. 12-2: LEDs at the CDI+ splitter
12.3 Operating and error display
Start the measures specified in the following table if one of the LEDs is on.
LED Name Description Action
V
IN
LED is on Normal mode -
LED is off 24 V DC missing Check the cable of the voltage supply
which is connected to X1S1.
Video1 LED flashing
green
Image data is sent to the operator
display 1.
-
LED off The PC does not sent any image data
to the CDI+ splitter
-
Link1 LED green Communication active und operator
panel selected.
-
LED red Operator panel not selected and no
communication possible with the op-
erator panel
-
LED green
and red
Operator panel not selected, but the
communication is possible with the
operator panel
-
LED off No communication possible with the
operator display, even though it is ac-
tive (selected via SEL or MOD)
-
IndraControl VAC 08.1 CDI+ Splitter 25/33
Device description
R911400465_Edition 01 Bosch Rexroth AG