NetDVR
| User’s Guide | Configuring the NetDVR
28
Bosch Security Systems | 2004-01
3.10 Setting schedule information (‘Schedule’ tab)
The settings in ‘Schedule’ are used to program
the recording status of the NetDVR. The
schedule setup of the individual channels and
of the output relays is done in their respective
windows. Clicking on the “Setup” button opens
these windows.
3.10.1 Status bar-graph
The horizontal bar graph indicates the
recording time schedule and status as follows:
•
As recording rate gets higher, the color
becomes denser.
•
There are two bars for each channel, one to
indicate the configuration of the normal
recording schedule (top), and the red one
to indicate the event condition (bottom).
•
A blue vertical bar indicates the current
time of the NetDVR.
External Sensor Input Devices
The Sensor input devices can be selected trigger event recording.
To enable the (alarm) sensor input ports:
•
Check the relevant boxes to enable the devices.
Note:
The NetDVR supports normally-closed (NC) type sensors only. These option check boxes only configure which
type of external device is used. The functions controlled by the relevant external device are configured in the
separate ‘Setup’ screens as detailed below.
The sensor (alarm) inputs comprise LED type photo-couplers. The inputs contacts must be
normally closed. Opening the input contact generates an alarm trigger.
Specification of the input: Input pull-up to 5 Vdc for an open input, current 12 mA for
closed contact.
3.10.2 Post Alarm
This function determines how long an image will be recorded after an alarm triggered event
has occurred. Valid entries are between 0 and 60 seconds.
Click the “Apply” button to upload the settings into the NetDVR.
Setting up a recording schedule:
•
Click on the ‘Setup’ button for the channel to be configured.
NetDVR.book Page 28 Wednesday, May 12, 2004 4:06 PM
