MIC IP fusion 9000i
(Optional) Installing a Sunshield | en
37
Bosch Security Systems
Installation Manual
2022-09 | 1.6 | F.01U.334.820
4. Align the sunshield shells so that the pins slide into the bolt heads on the faceplate.
5. Ensure that the sunshield mounting holes align with the holes in the rear of the camera
head. Install 4 screws and washers.
6. Ensure that the gap between the two sunshield halves is approximately 3.5 mm (1/8 in.).
7. If the rear gap is not parallel, rework to ensure that the pins are seated properly in the bolt
heads on the faceplate.
1.
If you will install an illuminator on a unit mounted in upright orientation:
Cut out the inset area in the sunshield shell with a pair of diagonal cutters. The inset area
provides space to attach the illuminator. Discard the cut-out plastic.
Note: This step does not apply to cameras mounted in inverted orientation.
2.
Note that when you install the sunshield correctly, the sunshield appears as in the
following figure.
