12
en | Introduction
MIC IP fusion 9000i
2022-09 | 1.6 | F.01U.334.820
Installation Manual
Bosch Security Systems
If a RADIUS server is used for network access control (802.1x authentication), you must
configure the device before the device can communicate with the network.
To configure the device, connect it directly to a computer using a network cable and then set
the service-level password.
Note:
If you cannot connect, the unit may have reached its maximum number of connections.
Depending on the device and network configuration, each unit can have up to 50 web browser
connections, or up to 100 connections via Bosch Video Client or BVMS.
2.4
Password protection in camera
The device is password-protected. The first time that any user accesses the device, the device
will prompt the user to set a password at the service level.
The camera requires a strong password. Follow the prompts in the dialog box, which specifies
what is required. The system measures the strength of the password that you enter.
Make sure the password obeys these conditions:
–
8 to 19 characters in length
–
Upper and lower case letters
–
Minimum of 1 digit
–
Minimum of 1 special character
These special characters are not allowed: '@', '&', '<', '>', ':', '+'
When you use Configuration Manager to access your device for the first time, you must set the
initial password of the device in Configuration Manager. The Users section (General > Unit
Access > Users) displays the message, "Before you can use this device you have to secure it
with an initial password."
Note
: After you set the initial password, a "lock" icon appears next to the device name in the
Devices
list in Configuration Manager.
You can also launch the device webpage directly. In the device webpage, an initial password
page appears, displaying input fields and a password strength gauge.
Enter the user name (“
service
”) and a password in the appropriate fields. Refer to the section
User Management
for more information.
After a service-level password is set for the device, the device displays a dialog box that
prompts users to enter the user name (“
service
”) and the service-level password every time
that they access the device.
1.
Fill in the fields
User name
and
Password
.
2.
Click
OK
. If the password is correct, the desired page appears.
Note
: New releases of software may require you to set a new and stronger password.
