en
Appliance door
24
5.
Remove the two middle panels along with their
holders.
Note:
The two middle panels are not fastened using
retaining pins; instead, they are held in place using
holders.
6.
Remove the holders to separate the two middle
panels from one another.
7.
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Fitting the door panels
1.
Reinsert the two middle panels.
Notes
– You will know that you have inserted the two
middle panels correctly when you can see the
"Low-E" symbol on both panels.
– Make sure that the panels are seated correctly.
All holders must lay flat against the outer panel.
2.
Reinsert the inner panel.
Note:
The panel must first be inserted into the
retaining bar. The two fastening pins must then
engage in the holders provided for them.
3.
Remove the locking pins and close the oven door.
Removing and fitting the appliance door
If the oven is very heavily soiled, the oven door can be
removed for easier cleaning. Normally, however, this is
not necessary.
Removing the appliance door
1.
Open the oven door fully.
2.
Lock both hinges on the left and right using the
locking pin
(a)
.
Note:
The locking pins must be fully inserted into the
holes in the hinges.
3.
Grip the oven door on either side with both hands
and close the oven door by approx. 30°
(b)
.
4.
Raise the oven door slightly and pull it out.
Note:
Do not fully close the oven door. The hinges
could become bent and the enamel could be
damaged.
Fitting the appliance door
1.
Grip the oven door on either side with both hands.
2.
Slide the hinges into the slots in the oven
(a).
Note:
The notch below the hinges must engage into
the frame of the oven
(b)
.
3.
Lower the door downwards.
4.
Remove the locking pins.
:
Warning – Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call after-sales
service.
:
Warning – Risk of injury!
The door may not close properly if the door hinges have
not engaged correctly. This will allow heat to escape
and the parts of the appliance may become very hot. To
prevent this from happening, remove the door again.
Then refit the door as shown in the drawing, making
sure that the groove on the underside of the hinges
engages in the oven frame.
D
E
E
D
Summary of Contents for HSB838357A
Page 1: ...en Instruction manual Free standing cooker HSB838357A ...
Page 2: ......
Page 30: ...6 ...
Page 31: ...6 ...
