English 8
1 Parts Bag containing:
2 - Screws,
1/4-20 x .50
(12.7mm) Hex
Head
2 - Screws, #8-18
x .375 (9.5mm)
Phillips
8 - Wood Screws, #10
x .50 (12.7mm) Phillips
Round Head
2 - End Cap Trim
1 - Plastic
installation template
(see pg. 14
)
1 - Electrical Panel
2 - 2-in. (51mm)
Support Legs
2 - 4-in. (102mm)
Support Legs
2 - Upper Support Brackets
DOWNDRAFT
HDD80050UC, HDD86050UC
HOTTE ENCASTRÉE HDD80050UC, HDD86050UC
TIRO DESCENDENTE HDD80050UC, HDD86050UC
Installation instructions
.................
2
Instructions d’installation
............
19
Instrucciones de instalación
.......
36
Installation
instructions
Use and care manual
...................
2
Manuel d’utilisation et
d’entretien
...................................
15
Manual de uso y cuidado
............
28
DOWNDRAFT
HOOD HDD80050UC, HDD86050UC
HOTTE À
TIRAGE DESCENDANT
HDD80050UC, HDD86050UC
VENTILADOR DE
TIRO DESCENDENTE
HDD80050UC, HDD86050UC
Use and Care guide
Wiring diagram
Downdraft Ventilator Housing
BEFORE YOU BEGIN
Installation review
This downdraft system can be used to exhaust cooking
by-products such as heat, steam, and smoke that may
be created while cooking using gas or electric cooktops.
With its versatile design, there are ive (5) basic discharge
options - left, right, rear, front and recirculation. It is
important to irst plan your installation. The purchase of
additional accessories to complete the installation may be
necessary.
It can be mounted in an island, peninsula, or conventional
wall location. The blower (purchase separately) and
electrical panel can be mounted to the downdraft unit,
inside the cabinet, or in a convenient remote location.
This unit can be easily installed following these basic
steps:
•
Plan the installation.
•
Cut out the countertop opening.
•
Prepare the downdraft housing.
•
Cut out the cabinet opening for discharge.
•
Mount the downdraft in the cabinet.
•
Install gas cooktop seal kit accessory, if applicable.
•
Connect the ductwork and install the blower.
•
Install downdraft electrical panel, if in remote
location.
•
Install the cooking appliance.
•
Install end caps to downdraft.
Parts supplied
•
Check the operation.
Note: the high level of air low of this appliance may effect
the gas lame on some types of gas cooktops. This is
NORMAL and will cause no harm, but can be corrected
by lowering the speed of the blower.
Tools needed
•
Measuring tape
•
Pencil
•
Phillips screwdriver #2
•
Nut drivers - 11/32” (8.7mm), 3/8” (9.5mm), 7/16”
(11.1mm)
•
Box-end wrench
•
Spirit-level
•
Aluminum tape (DO NOT use insulating tape)
•
Saw
•
Tin snips
•
Work gloves
