Bosch GCM 12 GDL Professional, Original Instructions Manual

Page: 41 / 480

English | 41
Bosch Power Tools 1 609 92A 285 | (11.11.15)
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Ceiling Strips/Mouldings (According to US Standard)
Settings Placed
against the
fence Lying flat on
the saw table
Floor strip/moulding Left side Right side Left side Right side
Inner corner Horizontal mitre angle 45° left 45° right 0° 0°
Bevel angle 0° 0° 45° left 45° right
Positioning of work-
piece Bottom edge on
saw table
Bottom edge on
saw table
Upper edge against
the fence
Upper edge against
the fence
The finished work-
piece is located ... ... to the left of the
cut
... to the right of the
cut
... to the left of the
cut
... to the right of the
cut
Outer corner Horizontal mitre angle 45° right 45° left 0° 0°
Bevel angle 0° 0° 45° right 45° left
Positioning of work-
piece Bottom edge on
saw table
Bottom edge on
saw table
Upper edge against
the fence
Upper edge against
the fence
The finished work-
piece is located ... ... to the left of the
cut
... to the right of the
cut
... to the left of the
cut
... to the right of the
cut
To cut ceiling strips/mouldings facing flat on the saw table, the mitre angle must be set to 31.6° (saw
table must be turned left or right) and the bevel angle must be set to 33.9° (glide arm tilted left or right).
The following table includes information on sawing ceiling strips/mouldings.
Settings Placed
against the
fence Lying flat on
the saw table
Ceiling strip/moulding Left side Right side Left side Right side
Inner corner Horizontal mitre an-
gle
45° right 45° left 31.6° right 31.6° left
Bevel angle 0° 0° 33.9° left 33.9° right
Positioning of work-
piece Bottom edge
against the fence
Bottom edge
against the fence
Upper edge against
the fence
Upper edge against
the fence
The finished work-
piece is located ... ... to the right of the
cut
... to the left of the
cut
... to the left of the
cut
... to the right of the
cut
Outer corner Horizontal mitre an-
gle
45° left 45° right 31.6° left 31.6° right
Bevel angle 0° 0° 33.9° right 33.9° left
Positioning of work-
piece Bottom edge
against the fence
Bottom edge
against the fence
Upper edge against
the fence
Upper edge against
the fence
The finished work-
piece is located ... ... to the right of the
cut
... to the left of the
cut
... to the left of the
cut
... to the right of the
cut
52°
38°
52°
OBJ_BUCH-1360-003.book Page 41 Wednesday, November 11, 2015 2:13 PM