FLEXIDOME IP indoor 8000i
Hardware installation | en
13
Bosch Security Systems B.V.
Installation manual
2021-08 | 01 |
6
Hardware installation
!
Caution!
Do not remove the bubble to move the camera lens manually.
The lens system is motorized for easy commissioning. Moving these parts manually will break
the gears and damage the camera. In order to move or focus the camera lens, always use the
motorized PTRZ controls mentioned in this manual. Removal of the bubble is only allowed for
bubble replacement.
6.1
Installing the mounting plate
The mounting plate is used to fix the camera to a flat surface. It offers different holes and
slots for a variety of fixing options.
5
3
1 10.2 cm / 4 in. Square junction box
2 Pole mount (NDA-8001-PLEN/
NDA-8001-IC/NDA-U-PMAL/NDA-U-
PMAS)/Corner mount (NDA-U-CMA)
3 Single gang box or universal slot,
45 mm / 1.8 in to 85 mm/3.3 in
4 Double gang box
5 Ceiling/wall mount and pendant
interface plate (NDA-8000-PIP)
Installation options
The camera has two configurations for surface mounting:
–
Refer to
Installing the mounting plate without conduit, page 14, if the wires are not on
the outside of the surface.
–
Refer to
Installing the mounting plate with conduit, page 15, if the wires are on the
outside of the surface.
