16
en | Hardware installation
FLEXIDOME IP indoor 8000i
2021-08 | 01 |
Installation manual
Bosch Security Systems B.V.
1.
Remove the conduit plate from the box.
2.
Mark the position of the hole on the surface.
3.
Drill the hole with the appropriate diameter drill.
4.
Install a plug in the hole.
5.
Select the applicable conduit plate adapter and install it on the conduit plate:
–
If the conduit is M25 / ¾ in., use the conduit plate adapter with the larger hole
(mounted by default).
–
If the conduit is M20 / ½ in., use the conduit plate adapter with the smaller hole.
–
If the conduit or cable diameter is smaller than M20, use the rubber adapter with the
conduit plate adapter with the larger hole. The rubber must be perforated to put the
conduit or cable through.
6.
Put the cable through the hole of the conduit plate.
7.
Attach the conduit plate with the conduit plate adapter to the surface with the washer
and a 5-6 mm (0.2 in.) screw. Tighten the screw between 2.5 and 4 Nm (1.8 lbfft and
3 lbfft).
8.
Remove the mounting plate from the box.
9.
Mark the positions of the holes on the surface. The mounting plate has only one side
available for the conduit. Make sure to position it accordingly.
