Bosch DCN-SWSACC, Software Manual

Page: 7 / 28

Bosch DCN Standalone Automatic Camera
Control
Installation | en 7
Bosch Security Systems B.V. Software Manual DCN-SWSACC_V4.0 | V1.0 | 2011.10
2.1.2 Operation
1. Make the connections according the image below:
–
– Refer to Section 2.3 Cables for cable type 3.
2.2 AutoDome
2.2.1 Configuration
1. Set the communication settings:
– AutoDome : set the baud-rate to 9600. Please refer to the AutoDome user manual
how to set the baud-rate.
– DCN-CCU2 : set the protocol for the serial port via menu 8H to AutoDome.
– DCN-CCU (S500): set the protocol for serial port which is connected to the
temporarily PC to camera control and set the baud-rate to 9600.
–
– DCN-NCO : set the baud-rate for camera control to 9600 using menu item 7l.
2. Make the connections to the temporarily PC according the image below:
–
– Refer to Section 2.3 Cables for cable types 1,6*, 4 and 6** (**optional: to see a video
image of an AutoDome camera with IP-module in the browser of Assign & store).
3. Start the DCN-SWSACC software. Refer to Section 2.4 Software Installation .
– Configure the ‘camera control’ as described in Section 3 The DCN-SWSACC
application , Section 4 System , Section 5 Cameras and Section 6 Assign & store .
4. Disconnect the temporarily PC from the DCN system: and the AutoDome .