16
en |
Assign & store
Bosch DCN Standalone Automatic Camera
Control
DCN-SWSACC_V4.0 | V1.0 | 2011.10
Software Manual
Bosch Security Systems B.V.
6.1
Temporarily PC with 2 serial ports
The following preconditions of
Assign & store
are required:
1.
Both the DCN system and the Camera system are properly connected and have the
correct settings. Refer to
Section 2 Installation
for more details.
2.
PC Communication Settings
under workflow
Section 4 System
must correspond with the
hardware installation.
3.
The
Section 4.2 Video Url
must be defined to view the AutoDome video in the browser
window.
4.
Continue with
Section 6.1.1 Start configure
.
6.1.1
Start configure
1.
Click the
Start configure
button.
–
The
Start configure
button changes into
Stop configure
button.
2.
Now all connected units are retrieved from the DCN system. While retrieving a progress
window will be shown. If all units are retrieved they are shown in the Assignment list. By
default the first item in the list is selected, this is the
Overview
. This
Overview
will be
shown during the conference if none of the microphones is active or when the
Camera
movement time:
is not elapsed. The
Overview
(camera 1) is selected within the
Assignment list.
6.1.2
Assigning the overview
The
Overview
camera gives a general overview of the conference venue when all the
microphones are off. In case of Allegiant the
Overview
can also be used when an AutoDome
camera is moving from one preposition to another.
To assign:
1.
Select a
Camera:
2.
Select a
Preposition
if the selected camera is a moveable camera.
3.
Move the camera to the desired position.
4.
Click the
Assign & store
button. The
Camera:
and
Preposition
are assigned to the
Overview
and are stored in the Camera system.
After assignment of the
Overview
the first unit is selected to have a
Camera:
and
Preposition
assigned. The
Overview
camera can be either a non moveable or moveable (AutoDome)
camera. However, when AutoDome is selected as Camera system, the
Overview
is always a
preposition of the AutoDome.
CAUTION!
When the connection with the DCN system or Camera system fails the following error
messages could appear:
–
Connection failure. Refer to
Section 4.1 PC Communication Settings
–
Incompatible version of the DCN system.
–
Required authorizations missing.
Summary of Contents for DCN-SWSACC
Page 1: ...Bosch DCN Standalone Automatic Camera Control DCN SWSACC en Software Manual ...
Page 2: ......
Page 27: ......
