18
en |
Assign & store
Bosch DCN Standalone Automatic Camera
Control
DCN-SWSACC_V4.0 | V1.0 | 2011.10
Software Manual
Bosch Security Systems B.V.
6.2
Temporarily PC with 1 serial port
1.
Make a connection between the DCN system and the temporarily PC.
2.
In workflow
Section 4 System
set the
Section 4.1 PC Communication Settings
for DCN
system to the correct port.
3.
Start the configuration mode of the DCN system by clicking the
Start configure
.
–
Now all connected units are retrieved from the DCN system. While retrieving a
progress window might be show. If all units are retrieved they are shown in the
Assignment list.
4.
Click the
Stop configure
button to stop the DCN system configuration mode.
5.
Disconnect the DCN system from the temporarily PC.
6.
Connect the Camera system to the temporarily PC.
7.
In workflow
Section 4 System
set the
Section 4.1 PC Communication Settings
for DCN
system to
--None--
and for Camera system to the correct port.
8.
Continue with assigning preposition to the units as described in
Section 5 Cameras
.
Because the DCN system is not connected the selected unit will not flash the LEDs.
9.
If all cameras and prepositions are assigned, disconnect the Camera system and
reconnect the DCN system.
10. Change the
Section 4.1 PC Communication Settings
.
11. Start the
Section 7 Upload
.
Summary of Contents for DCN-SWSACC
Page 1: ...Bosch DCN Standalone Automatic Camera Control DCN SWSACC en Software Manual ...
Page 2: ......
Page 27: ......
