D621 Series
|
User's Guide | Remote Arming With Telephone, Area 1
Bosch Security Systems | 8/04 |
52
Remote Arming With Telephone,
Area 1
o
I can perform this command.
o
I cannot perform this command.
This function controls the built-in telephone arming feature
for Area 1. When enabled, the panel answers the phone on
the programmed ring count.
When the panel answers the phone, it
•
sounds three beeps and starts the handshake tone for
remote programming if the panel is All or Part On.
•
sounds one short beep, waits approximately 3 seconds,
and then sounds one long beep if the panel is off. Press
and hold the [5] key* for two seconds immediately after
the first short arming beep and before the long beep
begins.
•
arms if it detects a [5] key press from the telephone (All
On with Delay, faulted points are force-armed). The panel
sounds three beeps (new armed state) and then hangs up.
* If arming from a cell phone, quickly press the [5] key
three times. If pressing and holding the [5] key for 2
seconds from a house (land-line) phone does not produce
a tone long enough to arm Area 1, retry by quickly
pressing the [5] key three times.
Remotely disarming the panel cannot be done with a
telephone.
