D621 Series
|
User's Guide | Set Part 2 Points (Cmd 65)
Bosch Security Systems | 8/04 |
23
Set Part 2 Points (Cmd 65)
o
I can perform this command.
o
I cannot perform this command.
Use this command to select which points are armed when you
turn the system Part 2 On. This allows you to turn part of the
system on to detect intrusion, while the remaining part of the
system allows you to move freely without sounding an alarm.
1.
Make sure the system is turned off (All and Part indicators
are off).
2.
Press [Cmd] [6] [5]. The keypad may prompt you to enter
a valid passcode by flashing the Cmd indicator.
3.
Enter your passcode if necessary. The keypad indicates
which points are available for selections. Points that are
on steady are selected for Part 2, flashing points are
available for selection.
4.
Enter the Point Number you want to activate or
deactivate for Part 2 On followed by the [*] key. Repeat
this step until all points have been designated Yes or No
for Part 2 Mode (Yes = Active, ready to detect intrusion;
No = Non-Active, you can move freely without sounding
an alarm).
5.
Press [Cmd] to exit this command.
