BORETTI CRG916, User Manual

Page: 59 / 272

59
9.4 Cleaning the polished surfaces
Clean with a non-abrasive, scratchproof sponge dampened with warm water
and neutral soap or with a standard detergent for polished surfaces. Rinse and
dry carefully with a soft cloth.
Abrasive pastes, coarse wire pads, steel wool or
acid will damage the surfaces. Do not use alcohol.
9.5 Cleaning the wooden surfaces, accessories and parts in wood
We recommend using cleaning products normally available on the market.
These products ensure the wood is preserved over time. If these products are
not available, we recommend removing the dirt as soon as possible using a
cloth dampened with water and neutral soap. Rinse thoroughly and dry with a
soft cloth. Remove the larger incrustations and more stubborn residues using
a scratch-resistant scraper for wood or a special sponge designed for delicate
surfaces. Do not under any circumstances use metallic sponges or sharp
scrapers that may damage the surfaces.
Do not wash wooden accessories and parts in the dishwasher. Keep dry
and avoid extreme temperature changes. Excessive humidity and extreme
temperature changes may irrevocably deform the wooden accessories and
parts.
9.6 Cleaning the knobs and the control panel
Clean the knobs and the control panel with a damp cloth.
9.7 Cleaning the enamelled surfaces
To clean the grids and hob burners, remove them from their housing by lifting
them upwards as shown in the figure, and immerse them in a solution of warm
water and non-abrasive neutral detergent for about ten minutes. Rinse and
dry carefully. Do not wash the burners or the plates in the dishwasher. Always
check that none of the burner openings is clogged. Be sure to refit the burner
correctly, checking the flame is uniform. We recommend carrying out this
operation at least once a week and each time it is necessary.
EN
Bor
etti Manual CRG916 / CRI915 / User guide - Installation advice