bora PL540E, Operating And Installation Instructions

Page: 19 / 36

EN
19
Installation
www.bora.com
2
1
Abb. 6.19 Securing the cooktop extractor
[1] Tensioning screw
[2] Clamp
X X
Turn the four clamps [2] under the worktop.
X X
Tighten the clamp screws [1] with max. 10 Nm.
X X
Verify that the alignment is correct.
X X
Once all of the installation work is complete, seal the
devices with black, heat-resistant silicone sealant.
6.5.3 Preparing for installation – standard
set-up
INFO The floor unit must not be supported on the
plinth fan housing.
INFO For correct installation, the slide-in units of the
base cabinet must be shortened depending on
the installation situation.
X X
Now adjust the ducting parts to the height of the
worktop.
X X
Saw out the necessary cut-outs for the ducting in the
rear panel of the floor unit.
X X
Depending on the installation situation, adjust the
levelling feet on the floor unit as necessary.
X X
Prepare the plinth fan by attaching the sealing tape
depending on the installation situation.
X X
Secure the sealing tape to the inlet nozzle.
Installing the cooktop extractor
1
2
Abb. 6.17 Installing the cooktop extractor
[1] Cooktop cut-out
[2]
Cooktop extractor
X X
Place the cooktop extractor [2] in the middle of the
relevant worktop cut-out.
X X
Precisely position the cooktop extractor.
1
2
Abb. 6.18 Height adjustment plates
[1] Height adjustment plate
[2] Cooktop extractor
X X
If applicable, insert the height adjustment plates [1].