GB
22
Assembly
www.bora.com
X
X
Open the cover to the housing of the activated char-
coal filter [1] from below.
click
1
4
3
2
Fig. 6.16
Hooking in the frame of the flexible duct
[1]
Retaining groove of the housing of the activated charcoal
filter
[2]
Position shackles
[3]
Flexible duct frame
[4]
Lower lock
X
X
Insert the frame of the flexible duct into the retaining
groove of the housing of the activated charcoal filter
[1].
X
X
Make sure that both lateral position shackles [2] are in
the guide.
X
X
Move the frame upwards [3] until the lower [4] and
upper lock engage in the middle.
X
X
Make sure that the frame is inserted into the groove
of the housing [1] on all sides.
1
2
Fig. 6.17
Inserting the activated charcoal filter
[1]
Housing cover of the activated charcoal filter
[2]
Activated charcoal filter
X
X
Remove the packaging from the activated charcoal fil-
ters.
X
X
Insert the two activated charcoal filters [2] from
below.
Inserting the cooktop
5
4
3
2
1
Fig. 6.14 Insert the cooktop at an angle
[1]
Cooktop
[2]
Suction opening
[3]
Air inlet nozzle
[4]
Stainless steel grease filter
[5]
Worktop cut-out
X
X
Before inserting the device, remove the air inlet nozzle
[3] and the stainless steel grease filter [4].
X
X
Use the suction opening as something to grab hold of
during insertion.
X
X
Insert the cooktop at an angle into the worktop cut-
out [5]. The glass ceramic panel must be supported
along the entire rear width (e.g. using a strip of wood)
in the process.
1
Fig. 6.15 Opening the housing cover
[1]
Housing cover of the activated charcoal filter
Summary of Contents for BIA
Page 43: ......
