EN
23
Assembly
www.bora.com
[1]
Cooktop
[2]
Suction opening
[3]
Air inlet nozzle
[4]
Stainless steel grease filter
[5]
Worktop cut-out
[6]
Mounting bracket
For surface installation
X
X
Make sure that the sealing tape of the cooktop is
resting on the worktop.
For flush installation
X
X
Make sure that the sealing tape of the cooktop is
sealed well all the way round.
1
2
Fig. 6.17 Height adjustment plates
[1]
Cooktop
[2]
Height adjustment plates
X
X
If necessary insert height adjustment plates [2].
X
X
Fasten the cooktop using the mounting brackets [6] at
the worktop.
X
X
Afterwards, insert the stainless steel grease filter [4]
and air inlet nozzle [3].
X
X
Seal the surrounding gap with a black heat-resistant
silicone sealing compound.
6.7 Installing exhaust air duct variant
(BHA)
INFO
National and regional laws and regulations must
be followed when executing the exhaust air duct.
Sufficient intake air must be provided.
6.7.1 Using the cooktop extractor with a
fireplace which does not depend on
room air
Fireplaces depending on room air (e.g. gas, oil, wood
or coal-fired heaters, continuous-flow water heaters,
instantaneous water heaters) draw in air from the room in
which they are installed and discharge the exhaust fumes
to the outside via an exhaust system (e.g. chimney).
When the cooktop extractor is used for exhaust air
operation, it draws in air from the room it is installed in
and from neighbouring rooms. If there is insufficient air, an
underpressure will occur. Toxic gases could be drawn out
of the chimney or extraction duct and back into the room.
X
X
Hang the frame of the flexible duct into the retaining
groove on the activated charcoal filter housing [2].
X
X
Make sure that the two lateral position shackles [1] are
in the guide.
X
X
Slide the frame [3] up until the bottom lock [4] and the
upper lock engage in the middle.
X
X
Make sure that the frame is fitted all around in the
groove of the activated charcoal filter housing.
1
2
Fig. 6.15
Inserting the activated charcoal filter
[1]
Housing cover of the activated charcoal filter
[2]
Activated charcoal filter
X
X
Remove the packaging from the activated charcoal
filters.
X
X
Insert the two activated charcoal filters [2] from below.
X
X
Note the flow direction of the filter. This is indicated by
an arrow.
X
X
Close the cover to the housing [1].
5
4
3
2
1
6
5
1
Fig. 6.16 Securing the cooktop in the middle
Summary of Contents for BHA
Page 41: ...EN 41 Notes www bora com 12 Notes...
Page 42: ...EN 42 Notes www bora com...
Page 43: ......
