EN
22
Assembly
www.bora.com
[1]
Cooktop
[2]
Suction opening
[3]
Air inlet nozzle
[4]
Stainless steel grease filter
[5]
Worktop cut-out
X
X
Before inserting, remove the air inlet nozzle [3] and the
stainless steel grease filter [4].
X
X
Use the suction opening [2] as a handle when inserting.
X
X
Lift the cooktop [1] diagonally into the worktop cut-out [5]
X
X
Place the cooktop [1] in the centre of the worktop cut-
out [5].
X
X
Align the cooktop precisely.
1
2
3
1
Fig. 6.13 Opening the housing cover
[1]
Outer locks
[2]
Middle lock
[3]
Housing of the activated charcoal filter
X
X
Fold down the cover of the activated charcoal filter
housing [3] from below by opening the two outer locks
[1] and the middle lock [2].
click
2
4
3
1
Fig. 6.14
Hooking in the frame of the flexible duct
[1]
Position shackles
[2]
Retaining groove on the activated charcoal filter housing
[3]
Flexible duct frame
[4]
Bottom lock
X
X
Using the included drilling template, draw the return
flow aperture and the connection bores in the middle
of the cooktop based on the installation dimensions.
X
X
Saw out the return flow aperture.
X
X
Rough-drill the connection bores.
X
X
Decrease the height of the skirting boards or create
corresponding apertures in the base.
Screwing on the flexible duct
Fig. 6.11 Flexible duct with 6 EURO screws 6.3x10 mm
X
X
Using a screwdriver (not a cordless drill) screw the
flexible duct into the rear wall of the furniture until
hand-tight.
Inserting the cooktop
5
4
3
2
1
Fig. 6.12 Insert the cooktop at an angle
Summary of Contents for BHA
Page 41: ...EN 41 Notes www bora com 12 Notes...
Page 42: ...EN 42 Notes www bora com...
Page 43: ......
