EN
22
Installation
www.bora.com
X
X
Use a screwdriver (not an electric screwdriver) to
screw the flexible duct to the back wall of the kitchen
unit until it is hand-tight.
Inserting the cooktop
5
4
3
2
1
Fig. 6.14 Insert the cooktop obliquely
[1]
Cooktop
[2]
Suction opening
[3]
Air inlet nozzle
[4]
Stainless steel grease filter
[5]
Worktop cut-out
X
X
Before inserting the cooktop, remove the air inlet
nozzle [3] and the stainless steel grease filter [4].
X
X
Use the suction opening as a handle during insertion.
X
X
Insert the cooktop obliquely into the worktop cut-out
[5].
1
Fig. 6.15 Opening the housing cover
[1]
Housing cover of the activated charcoal filter
X
X
Open the housing cover of the activated charcoal filter
[1] from below.
Q
Q
A minimum clearance of 25 mm between the back
furniture body wall and an adjacent kitchen unit or room
wall must be observed for the return flow aperture.
Preparing the back wall of the kitchen unit
X
X
Adjust the back wall according to the required
installation dimensions.
X
X
If applicable, move the back wall.
X
X
If necessary, extend the height of the back wall so that
the unit is closed to the front.
6 x ø5
Fig. 6.12 Cut-out and connection requirements
X
X
In the middle of the cooktop, use the drilling template
provided to mark the return flow aperture and
the connection drill holes in accordance with the
installation dimensions.
X
X
Saw out the return flow aperture.
X
X
Drill the connection drill holes.
X
X
Decrease the height of the skirting boards or create
corresponding openings in the plinth.
Screwing on the flexible duct
Fig. 6.13 Flexible duct with 6 EURO screws 6.3 x 10 mm
