bonitron M3460UC, Customer Reference Manual

Page: 27 / 56

User’s Manual
27
4.5.4.3.2. S
ET
S
TATUS
T
IMER
On this screen, the user may set how long the system will wait after
the last button press before returning to the Status screen. If this
time is set to 0 seconds, the Status screen timer is disabled, and
the system will not leave the present screen without external
stimulus.
Up : Increment digit
Down : Decrement digit
Left/Right : Move cursor
Enter : Confirm time
Cancel : Configuration menu
4.5.4.3.3. S
TATUS
D
ISPLAYS
The user may select which two voltages or currents will be
displayed on the default status screen.
4.6.
F
AULTS
The 3660DD5 monitors several faults. Some latch until reset, either from the display
or by toggling the appropriate enable input. Faults that do not latch automatically reset
when the fault condition is no longer present. Each fault activates one of the two fault
outputs. Some faults disable either the ride-thru or charger until they are reset. See
Table 4-1 to determine which properties apply to each fault.
Table 4-1: KIT 3660DD5 Faults
F
AULT
D
ESCRIPTION
F
AULT
1 F
AULT
2 L
ATCH
R
IDE
-T
HRU
D
ISABLE
C
HARGER
D
ISABLE
Output Undervoltage x
Storage Undervoltage x x Configurable
Storage Overvoltage x x x
Ride-Thru Not Ready x
Precharge Not Complete x
Ride-Thru Overtemp x x Configurable
Phase 1 Loss x
Phase 2 Loss x
Phase 3 Loss x
Ride-Thru Active Time x x Configurable
Storage Imbalance x x x
Storage Overtemp x x x
Charger Fault x
Discharge Resistor Overtemp x x
Display Communication Loss x
Interface Communication Loss x
4.6.1. O
UTPUT
U
NDERVOLTAGE
This fault indicates that the bus voltage has dropped below the level set in
the Super menu.
4.6.2. S
TORAGE
U
NDERVOLTAGE
This fault indicates that the storage voltage has dropped below the level set
in the Super menu. This fault can be configured in the Super Menu to disable