-
2
1 Lock for fresh water reservoir
2 Switch for brush drive
3 Switch for detergent solution
4 Hose for detergent solution
5 Lint sieve (suction)
6 Lock of pushing handle
7 Release button for the transport wheel
8 Transport wheel
9 Push handle
10 Strain relief clamp
11 Support of the transport wheel
12 Clip
13 Fresh water tank
14 waste water tank
15 Push-button for vacuum bar change
16 Float
17 Button for brush change
18 Chassis
19 Vacuum bar
20 Brushing rollers
21 Rotating handle for brush contact pres-
sure
22 Pedal to lower vacuum bar
23 Mains plug
24 Carrying handle for waste water tank
25 Fresh water tank cover
Slide the upper slider half onto the low-
er slider half.
ATTENTION
Risk of damage. Do not open cable loops
during assembly.
Align the borings (2 possible height ad-
justments).
Connect the slider halves to the lock
screws, discs and star grips.
Fasten the cable to the slider using
clips.
Insert the transport wheel axles into the
borings on the appliance and lock them.
The brushes must be installed before the
initial operation (see "Maintenance works").
Note:
To put the brush drive out of operation im-
mediately release the brush drive switch.
Operating elements
24
25
Before Commissioning
Installing the pushing handle
Installing the transport wheels
Installing the Brushes
Operation
11
EN
Summary of Contents for 1.783 Series
Page 2: ...2 ...