BOMBARDIER Quest Max 2004, Operator'S Manual

Page: 138 / 172

136
Speedometer
The speedometer is lighted with LEDs.
If one LED burns, replace the speedom-
eter. The LEDs are not available sepa-
rately.
Drive Train
Quest MAX and Traxter MAX Series
Front Propeller Shaft
Check the front propeller shaft boots
for cracks, tears or other damages.
See an authorized Bombardier ATV
dealer if any damage is detected.
Check if the propeller shaft is straight
and not damage.
Rear Propeller Shaft
Lubricate the rear propeller shaft U-
joint steadily. Use synthetic grease
(P/N 293 550 033).
Drive Shaft Boot/Protector
Quest MAX and Traxter MAX Series
Visually inspect drive shaft protectors
and boot conditions. Check protectors
for damage or rubbing against shafts.
Check boots for cracks, tears, leaking
grease etc. Repair or replace damaged
parts as necessary.
1. Drive shaft protector
2. Drive shaft boots
Wheel
Quest MAX and Traxter MAX Series
Occasionally, wheel nuts should be re-
moved to apply anti-seize lubricant on
studs to ease further removal. This is
particularly important when vehicle is
used in salt-water environment or in
mud. Remove one nut at a time, lubri-
cate then retorque.
Wheel Bearing Condition
Quest MAX and Traxter MAX Series
Push and pull the wheels from the up-
per edge to feel the play. See an autho-
rized Bombardier ATV dealer if there is
any play.
Tires/Wheels
Quest MAX and Traxter MAX Series
Tire Pressure
V00A14Y
1
2

WARNING
Tire pressure greatly affects vehi-
cle handling and stability. Under-
pressure may cause tire to deflate
and rotate on wheel. Overpres-
sure may burst the tire. Always
follow recommended pressure.
Since tires are low-pressure types,
a manual pump should be used.
V01A0MY
vmo2004_011a.book Page 136 Thursday, May 15, 2003 1:46 PM