BOMBARDIER outlander max 650 efi 2006, Operator'S Manual

Page: 76 / 145

Multi-Function Display Messages
MESSAGE DESCRIPTION
X 100 RPM
When the speedometer is in RPM MODE, multi-function display
will show “X 100 RPM” if the Speed/RPM mode is selected.
INVALID KEY
Indicates that you have used the wrong ignition key, use the
proper key for this vehicle.
It is also possible that the ignition key has a bad contact, remove
and clean key.
PARK BRAKE
Is displayed when parking brake is applied for more than 15
seconds.
LO BATT
Low battery voltage, check battery voltage and charging system.
HI BATT High battery voltage, check battery voltage and charging system.
LOW OIL (1)
Engine low oil pressure, stop engine immediately and check oil
level.
HI TEMP (2)
Engine is overheating, refer to ENGINE OVERHEAT in SPECIAL
PROCEDURES .
LIMP HOME
Serious fault on the engine that can change the normal operation
of the engine, check engine indicator lamp will also blink, refer
to
TROUBLESHOOTING for more details.
CHECK ENGINE
Engine fault, check engine indicator lamp will also be ON, refer
to
TROUBLESHOOTING for more details.
MAINTENANCE
SOON Periodic maintenance required. See an authorized Bombardier
ATV dealer.
NO ECM
COMMUNICATION Communication error between speedometer and engine control
module (ECM), contact an authorized Bombardier ATV dealer.
CAUTION: (1) If the light does not turn off right after engine starting, stop
engine. Check engine oil level. Refill if necessary. If the oil level is good,
see an authorized Bombardier ATV dealer. Do not use the vehicle until re-
paired.
CAUTION: (2) If the light does not turn off right after engine starting, stop
engine. See an authorized Bombardier ATV dealer. Do not use the vehicle
until repaired.
_____________________
75