14
|
Extended Interface
To reset the VC-310SMI to its original settings, follow these steps:
1. Make sure the flash is off.
2. Press and hold the Test and Power buttons for 3 seconds, then release.
To reset the VC-310OP to its original settings, follow these steps:
1. Make sure the flash is off.
2. Press and hold the Test and Power buttons until the flash turns on, then release.
To reset the VC-310F to its original settings, follow these steps:
1. Make sure the flash is on.
2. Press and hold the Mode and Right buttons for 3 seconds, then release.
Extended Interface
Micro-B USB:
This flash supports firmware upgrades through the micro USB port on the side of the flash. In
order to ensure compatibility with future cameras, the VC-310’s firmware may be updated. This can be done to
ensure proper communication with new cameras or to add new features. Visit www.boltflashes.com/firmware
to check if a new firmware version has been released. Follow the online instructions to upgrade.
