Bohle GlassBuddy Basic, Operating Instructions Manual, Page: 31 / 35

EN
31 31
n
Error
- This error message appears if there is an
internal error in the Glass
Buddy
.
Solution: If the message Error is repeated,
the Glass Buddy should be
returned to the manufacturer for
inspection.
n
No Data
- This message appears if there is no data
in the memory that can be shown.
n
" Measurement in Basic mode not possible"
- This error message appears if types of glass
are being analysed which can only be
measured with Glass Buddy Plus.
Solution: Software Upgrade to
Glass Buddy Plus
11 Charge battery
When the battery is fully charged, the device can
work permanently for 8 hours. When charged, the
battery usually lasts for one to two weeks under
normal conditions of use. At a battery status of
approximately 10% you will be shown the message
Charge battery . Measurements can still be taken
but the Glass Buddy should be charged as soon as
possible to ensure problem-free operation.
Connect the Glass Buddy to your PC or laptop using
the supplied USB cable. To charge the battery at
the mains supply or in the car, we also have a USB
power set available as an accessory (BO 5164751);
this contains interchangeable plugs for a number of
countries (EU/US/UK/AU).
Using the car adapter you can charge the Glass-
Buddy whilst driving from one building site to the
next.
When the battery is almost empty, it takes approxi-
mately 120 minutes to charge it to 100% again (if
the Glass Buddy remains switched on during char-
ging, the charging time is longer). The Glass
Buddy
will indicate when the charging process is over. The
display will then show PC connection - battery is
charged . Nevertheless the Glass Buddy has to be
switched on for displaying this message.
The Glass Buddy contains a permanently installed
top quality Li-ion rechargeable battery with a very
long service life. If the performance of the battery
diminishes over the years, Bohle can replace the
battery.
12 Care and Maintenance
To avoid damage or malfunctions of your Glass Bud-
dy , please strictly observe the following:
n
The Glass
Buddy
must always be stored in the
supplied safety case as this is the only way to
effectively prevent damage.
n
To avoid damage, the Glass Buddy must only
be operated and/or stored at temperatures
between 0° C and +40° C.
n
The Glass Buddy must not be exposed to
vibrations or impacts.
n
Only clean the display window and casing
with a dry, clean and soft cloth. Never use
cleaning liquids or thinning agents.
The laser opening and the sensor slit may only
be cleaned with a dry, clean and soft brush and/or
with clean compressed air.
n
Repairs may only be performed by the
manufacturer; please contact your dealer.
Measuring range depending on the gap between
panes (gap).