Installation
4.3
Assembly work
Page 38
BOGE Operating instructions for scroll compressors, series EO 6...EO 22 D
4.3 Assembly work
General
BOGE compressors are delivered as complete units ready for connection. The
only work to be carried out during assembly is described in the following sec-
tions.
Prior to delivery, each compressor undergoes a test run at the factory. It is
carefully tested and set. However, damage during transit cannot be excluded.
–
Please check the compressor immediately after delivery and make a com-
plaint to the last carrier about any damage – even if the packaging is not
damaged. In order to secure your claim for damages against the shipping
company, we would advise you to temporarily leave the machines, equip-
ment and packaging materials in the condition in which you found them
when you identified the damage.
–
Inspect the compressor for external transport damage before commis-
sioning.
–
Observe the compressor very closely during commissioning and the
subsequent test run.
–
Switch the compressor off immediately if malfunctions or faults occur.
Inform BOGE Service.
4.4 Establishing the connections
CAUTION
Risk of injury due to mechanical hazards, e.g. moving parts or sharp
edges!
All assembly work must only be carried out by duly authorised and experi-
enced skilled personnel (BOGE Service personnel).
Î
Lay all power supply lines in a trip-proof and barrier-free manner so that
potential accidents can be avoided.
WARNING
Risk of injury due to mechanical hazards, e.g. moving parts or sharp
edges!
Danger of property damage or malfunctions due to incorrect connec-
tions!
The compressor should only be connected by duly authorised and experi-
enced skilled personnel.
Î
Wear PPE.
