Installation
Connection to Power Supply
Please follow the specification at the end of this manual
when selecting the power supply outlet for the unit, ensure
the power supply is suitable before connecting the unit.
Please do not use the lead with other devices
Check the Integrity of the electrical power cable, if the
supply cord is damaged the extraction unit should not be
connected to the mains. The supply cord should only be
replaced by a BOFA engineer as an electrical safety test may
be required after replacement.
The unit
MUST
be connected to a properly earthed outlet.
If your unit was ordered with any optional extras please
read section 4.03
before the power connection is made as
additional connections may be required before power is
connected to the extractor.
The internal
compressor is a voltage specific component
that MUST be set correctly before any mains voltage is
applied to the extractor.
The voltage selector switch can be found on the
mounting base of the compressor inside the unit. Please
ensure the switch is set correctly, Failure to do this will
cause irreversible damage to the compressor
Connect the power cable to an isolated electrical supply.
The mains socket should be installed near the extractor it
should be easily accessible and able to be switched On/ Off.
The cable run should be arranged so as not to create a trip
hazard.
230V
115V
02
4
