BOECO TC-PRO Thermal Cycler
1
Important Note
1
CONVENTIONS
Note:
Because there is important information in this item, please read it carefully.
Failure to follow the advice here will possibly result in damage or malfunctioning
of the Thermal Cycler.
Warning!
This symbol means that you should be cautious to take an operation/procedure.
Failure to follow the requirements in this item will possibly result in personal
injury.
During the operation, maintenance, or repair of the BOECO TC-PRO Thermal Cycler, the
following safety measures should be taken. Otherwise, the guard provided by the Thermal
Cycler is likely to be damaged, while the rated safety level to be reduced, and the rated
operation conditions to be affected.
The Boeckel + Co (GmbH + Co) KG shall not be in any way responsible for the
consequences resulted from operators not following the requirements
Note:
The Thermal Cycler, complying with the National Standard GB4793.1, is a
general instrument of class
Ⅱ
, the p
rotection
d
egree
is IP20. It is intended for
indoor use.
a) Grounding Considerations
A.C. power’s grounding should be grounded reliably for fear of an electric shock. The 3-pin
plug with the Thermal Cycler’s power line is a safety device that should be matched with a
grounded socket. Never let the third ground pin floating. If the 3-pin plug cannot be inserted,
it is recommended to ask an electrician to install an appropriate power socket.
b) Keep Away from Electric Circuits
The operator is not allowed to open the Thermal Cycler. To changing components or adjust
certain parameters inside the device must only be accomplished by the certificated
professional maintenance personnel. Do not change elements while the power is still on.
c) A.C. Power Considerations
Before turn on the power, always check if the mains voltage is within the required A.C.
（
±
10%
difference is allowed.
）
and whether the current rating of the power socket meet the required
specification.
d) A.C. Power Line Considerations
As an accessory of the Thermal Cycler, the A.C. power line used should be a default one. If