BodyCraft SW-95.0225-G, Assembly And Operating Instructions Manual

Page: 26 / 58

26
Elite
Step 10: Install Connect Cable
1. See Fig. C1: Screw the threaded end of CONNECT CABLE (85) into the SINGLE PULLEY BLOCK
(24).
⚠ CAUTION
At least one third of the thread must be screwed into the slot.
2. See Fig. C2: Route the cable up and over Pulley C2 mounted on TOP FRAME (4), using one 3/8” X
2-3/4“ HEX BOLT (142) and one 3/8“ NYLA-NUT (170).
3. See Fig. C3: Route the cable down and around Pulley C3 mounted on the MAIN FRAME (1), using
one 3/8” X 1-3/4” HEX BOLT (134) and one 3/8” NYLA-NUT (170).
4. See Fig. C4: Continue to route cable up and around the Pulley C4 mounted at second hole of
ADJ. PULLEY BLOCK (23), using one 3/8” X 1-3/4” HEX BOLT (134) and one 3/8” NYLA-NUT (170).
5. See Figs. C5/C6: Route the cable down and around Pulley C5 mounted in the top of the DOUBLE
PULLEY BLOCK (25) using one 3/8” X 1-3/4” HEX BOLT (134) and one 3/8” NYLA-NUT (170). Finish
by routing the cable up to screw into the threaded receptor welded to the TOP FRAME (4).
⚠ CAUTION
At least one third of the thread must be screwed into the slot.