BodyCraft SW-95.0225-G, Assembly And Operating Instructions Manual

Page: 25 / 58

25
Step 9: Install Leg Extension Cable
1. See Fig. E1: Hook the steel ball end of the LEG EXTENSION CABLE (84) into the groove in the LEG
CURL CAM (22).
2. See Fig. E2: Route the cable in between two Pulleys E2 and E3 and secure using one 3/8” X 75L
FLAT PIN BOLT (141), four 3/8” SMALLER WASHERS (164) and one M6 X 12L MALE SCREW (147)
each, as shown in FIG STEP 1. Continue routing cable down and around Pulley E4 mounted in a
slot in the front of the MAIN FRAME (1) using one 3/8” X 75L FLAT PIN BOLT (141) and one M6 X
12L MALE SCREW (147).
3. See Fig. E5/E6/E7 Route the cable down around Pulley E5 mounted under the SEAT ADJ. FRAME
(12), and secure using one 3/8” X 1-3/4” HEX BOLT (134) and one 3/8” NYLA-NUT (170). Route the
cable around Pulley E6 mounted under rear part of the MAIN FRAME (1) and secure using one
4-1/2” PULLEY (100), one 3/8” X 1-3/4” HEX BOLT (134) and one 3/8” NYLA-NUT (170). Screw the
threaded bolt-end into the SINGLE PULLEY BLOCK (24).
⚠ CAUTION
At least one third of the thread must be screwed into the slot.