BodyCraft SW-95.0225-G, Assembly And Operating Instructions Manual

Page: 20 / 58

20
Elite
Step 5: Assemble Press Arm
1. Secure the PLASTIC COVER (74) to the front of the PRESS ARM SUPPORT (9) using one M5 X 63L
SCREW (153). Attach the PRESS ARM SUPPORT (9) to the TOP FRAME (4) by aligning the holes
and inserting the AXLE (35). Secure and tighten using two 1/2” LARGER WASHERS (160) and two
1/2” NYLA-NUTS (169). Cap with two 1/2” CAP NUTS (103).
2. Attach the PRESS ARM (7) to the PRESS ARM SUPPORT (9) by aligning the holes and inserting the
PRESS ARM AXLE (38). The LONGER POP PIN (125) should seat into one of the adjustment holes
in the PRESS ARM SUPPORT (9).
3. Secure the PRESS ARM AXLE (38) by tightening the preinstalled 5/16” X 1/4” SET SCREW (158).
4. Fasten the PLASTIC COVER (74) to the front side of the PRESS ARM SUPPORT (9) with the M5 X
63L SCREW (153).
5. Attach the PRESS ARM PANEL (56) to the PRESS ARM (7) using four M6 WASHERS (185), eight
SMALL SEALING RINGS (184) and four M6 X 12L MALE SCREWS (147).
6. Install two END CAPS (102) into the bottom of the PRESS ARM (7) using a rubber mallet.