BodyCraft ECT1000g, Owner'S Manual

Page: 11 / 28

8
Maintenance
Cleaning
The elliptical trainer can be cleaned with a soft cloth and mild detergent. Do not use
abrasives or solvents on plastic parts. Please wipe your perspiration off the elliptical
trainer after each use. Be careful to not get excessive moisture on the computer display
panel as this might cause an electrical hazard or electronics to fail. Please keep the
elliptical trainer, especially the computer console out of direct sunlight to prevent screen
damage. Please inspect all assembly bolts and pedals on the machine for proper
tightness every week.
Storage
Store the elliptical trainer in a clean and dry environment away from children.
Maintenance and Adjustment
Optional Power Supply
Your Elliptical Trainer uses a generator to operate the computer and resistance mechanism.
The computer uses a rechargeable battery to maintain power if the user were to stop or drop
below the minimum rpm’s needed for the computer to operate properly. If you haven’t used
your elliptical trainer for a long period of time, the battery can drain. You can recharge it by
simply working out or it can also be charged using an optional power supply. Please contact
Bodycraft for additional information.
There are 5 LEVELERS that prevent the elliptical trainer from wobbling or shaking
during exercise. Follow these steps to level your machine.
1. Start by threading in the MIDDLE LEVELER completely into the frame.
2 Adjust the 2 FRONT and 2 REAR LEVELERS on the MAIN FRAME as needed to
stabilize the elliptical trainer.
3 Adjust the MIDDLE LEVELER until it just touches the floor.
4. Test for stability. If satisfied, tighten each of the 6 Jam Nuts up into the frame
(located on each of the levelers) to lock your adjustments.
Front Levelers x2 Middle Leveler x1 Rear Levelers x2
Leveler Adjustment