BodyCraft BC-XFT, Assembly And Operating Instructions Manual

Page: 22 / 60

22
XFT
Step 5a: Assembly of the Vertical Guide Rods (Normal/High Ceiling Height)
࣑ ATTENTION
This assembly step requires a ceiling height of 95” or approximately 241 cm. If you have a lower
ceiling height of 84.5” or approximately 214 cm, skip this step and proceed to step 5b instead.
1. Slide one 48mm rubber cushion (75) onto the upper portion of one solid linear guide rod (11).
2. Place another 48mm rubber cushion (75) onto the lower rod holder [fig. 2].
3. Loosen the top and bottom screws (116).
4. While holding the solid linear guide rod (11) at a slight angle, slide the top of the solid linear
guide rod (11) up through the upper rod holder. The bottom of the solid linear guide rod (11)
should be just above the connector frame (15) [fig. 3].
5. Align the bottom of the solid linear guide rod (11) with the linear bearing on the connector
frame (15).
6. Carefully and slowly lower the solid linear guide rod (11) through the linear bearing and the
48mm rubber cushion (75) and into the lower rod holder.
7. Retighten the screws (116).
8. Repeat the steps 1 to 7 on the other side.