BodyCraft BC-XFT, Assembly And Operating Instructions Manual

Page: 34 / 60

34
XFT
Step 10: Assembly of the Guide Rods and Weight Stack
L
NOTICE
If you have purchased the version with 19 weight plates (200 lbs), do not install the two stack
spacers (26). Only install the stack spacers (26) if you have purchased the version with 14 weight
plates (150 lbs).
1. Attach the selector rod (40) to the top plate (38) with one top plate bolt (103).
2. Tighten the top plate bolt (103).
3. Insert two plastic guide rod holders (72) into the base frame (1).
4. Insert both hollow guide rods (4) into the plastic guide rod holders (72) and base frame (1).
࣑ ATTENTION
+ Step 5 must only be carried out if you have the 150 lbs weight stack with 14 weight plates. If
you have the heavier weight stack, skip step 5 and proceed directly to step 6.
+ It is recommended to perform the following steps with two people.
5. Slide one stack spacer (26) over each of the hollow guide rods (4).
6. Slightly angle the hollow guide rods (4) forward like shown in the bottom left figure.
7. Slide one 64mm rubber cushion (74) over each of the hollow guide rods (4).
8. Carefully slide each of the 14 or 19 weight plates (39) over the hollow guide rods (4) one by one.
Make sure to align the weight plates (39) so the selector holes are on the bottom and all weight
plates facing forwards.
9. Carefully slide the top plate (38) with the assembled selector rod (40) over the hollow guide
rods (4). Make sure the selector rod (40) goes through the center holes of the weight plates (39).
10. Place the top guide rod holder (17) onto the top of both hollow guide rods (4).
11. Carefully return the hollow guide rods (4) to the upright position.
12. Attach the top guide rod holder (17) to the top frame (13) with two round screws (106).
13. Tighten the hollow guide rods (4) with two screws (116).