BodyCraft BC-XFT, Assembly And Operating Instructions Manual

Page: 40 / 60

40
XFT
Step 13: Assembly of the Low Cable and Pulleys
L
NOTICE
+ Before proceeding with the cable routing, carefully study the cable routing overview
beginning with L1.
+ Route the cable while simultaneously assembling the pulleys as you go.
+ The following steps show the assembly procedure for the right side of the machine. The
steps must be repeated for the left side as well.
1. Route the low cable (55) under one 90mm pulley (52) and attach the pulley (52) to the rotating
pulley holder (18) with one bolt (98) and one nylon nut (131). Make sure the ball end of the cable
is facing the outside of the machine like shown [L1].
2. Route the cable (55) over the 90mm pulley (52) mounted in the right top panel (22R) [L2].
3. Route the cable (55) under the two bolts [fig. 2] and around one 90mm pulley (52) and attach
the pulley (52) to the right top panel (22R) with one bolt (95) and one nylon nut (131) [L3].
4. Route the cable (55) down into and through the rear right upright frame (9R) [fig. 1].
5. Route the cable (55) under one 90mm pulley (52) and attach the pulley (52) to the rear right
upright frame (9R) with one bolt (98) and nylon nut (131) [L4].
6. Route the cable (55) under one 90mm pulley (52) and attach the pulley (52) to the right base leg
(2R) with one bolt (98) and one nylon nut (131) [L5].
7. Route the cable (55) over one 90mm pulley (52) and attach the pulley (52) to the lower part of
the double pulley block (36) with one bolt (98) and one nylon nut (131) [L6].
8. Route the cable (55) under two 90mm pulleys (52) and attach the pulleys (52) to the right base
leg (2R) with one bolt (98) and one nylon nut (131) each [L7, L8].
9. Attach the bolt end of the cable (55) to the bolt holder on the right pulley height adjuster (19R)
[L9].
10. Repeat the steps 1 to 9 on the left side with the second low cable (55).