BodyCraft BC-XFT, Assembly And Operating Instructions Manual

Page: 16 / 60

16
XFT
Step 2: Assembly of the Main Upright Frames, Part 1
1. Attach one oval plug (140) to the connector frame (15).
L
NOTICE
+ Please note that the following step musst be carried out for both main upright frames (5),
even though only one is shown.
+ Do not tighten the screws completely until instructed to.
2. Remove the pre-assembled bolt (A) and washer (B) that secure the weight cable from both main
upright frames (5).
3. Loosely attach one of the main upright frames (5) to the base frame (1) with four bolts (100),
eight washers (118) and four nylon nuts (131). Make sure the guide rod holder is facing the front
like shown.
4. Remove eight bolts (122) from the connector frame (15) [fig. 1].
5. Rotate the four steel plates (44) like shown in figure 2.
6. Attach the connector frame (15) to the main upright frame (5).