4: Use a 10mm wrench to
tighten the counter bolts (3). On
the right side, the tool should
be pulled downwards and on
the left side upwards to tighten.
5: The belt should be tightened
to approximately 125 kg/229
Hz. To measure this, a special
device can be bought at your
BODY BIKE Distributor.
6: Tighten the counter bolt (2)
on both sides of the cycle again.
Please note:
The belt should be equally
tightened on both sides.
The fl ywheel should be
parallel with the long main
side member.
POLY-V BELT
If the belt does not catch hold
of the fl ywheel, it needs to be
tightened.
1: Remove both service hatches
see fi gure 15 on page 10.
2: Loosen the bolts (1) on both
sides of the cycle with a 19mm
wrench, see fi gure 29.
3: Loosen the nuts (2) on the
counter bolt on both sides of
the cycle using a 10mm wrench,
see fi gure 30.
(1)
(2)
(3)
Figure 30
MAGNET PATH
Figure 31
7: Tighten the bolt(1) again on
both sides of the cycle.
8: Check that the magnet is
still passing the control box in
front of the arrow printed on
the back side of the control box,
see fi gure 31. If not, loosen the
screws holding the control box
to the frame and slide the box
in front of the magnet. Tighten
the two screws by hand.
9: Follow the steps in the
section ‘Calibration’ to ensure
accurate readings, see page 15.
M
AINTENANCE
BODY
BIKE
®
I N DOOR C YC L E
16
