Bodart & Gonay Infire EASY, Manual

Page: 34 / 37

34
FIRE IS TOO
INTENSE 16. UNCONTROLLED AIR SUPPLY - CHECK THE STOVE DOOR AND ASH PAN FOR
TIGHTNESS
17. WOOD USED IS OF A TOO SMALL
CROSS-SECTION - USE WOOD WITH A CROSS-SECTION OF ABOUT 12
TO 15 CM
18. MALFUNCTION OF THE AIR BOX - CONTROL THE MOVEMENT OF THE MOBILE AIR
FLAP
THE GLASS PANEL
BLACKENS CHECK CAUSES 5 – 7 – 9 – 10 – 11 -
12
- APPLY THE APPROPRIATE CORRECTIVE ACTION
19. CLEAN GLASS BEFORE LIGHTING - CLEAN THE GLASS CAREFULLY
20. UNCONTROLLED AIR SUPPLY - CHECK THE DOOR FOR TIGHTNESS
IMPORTANT
BACKFLOW WHEN
OPENING THE
DOOR CHECK CAUSES 3 - 4 - APPLY THE APPROPRIATE CORRECTIVE ACTION
21. DOOR OPENING IS TOO FAST - OPEN THE DOOR MORE SLOWLY
22. OPENING THE DOOR
IMMEDIATELY AFTER RELOADING - AVOID OPENING THE DOOR DURING THE
RELOADING PHASE
23. DOOR SWITCH MALFUNCTION
- CHECK THE POSITION OF THE SWITCH
- CHECK THE ELECTRICAL CONNECTIONS (BY THE
INSTALLER)
- REPLACEMENT BY THE INSTALLER
THE CONTROL
PANEL DOESN’T
LIGHT UP
24. ELECTRICAL POWER SUPPLY - CHECK THE POWER LINE (FUSE)
- CHECK THE PRESENCE OF VOLTAGE ON THE BOARD
BY PRESSING THE TEST BUTTON
(THEN PRESS AGAIN TO EXIT TEST MODE).
- REPLACE THE POWER SUPPLY
25. IN TEST MODE, THE FANS DO
NOT RUN - REPLACEMENT OF THE CABLE OR FANS BY THE
INSTALLER
THE RED LED LIGHT
OF THE
VENTILATION
MODE IS ON 26. CLOGGED FILTER - CLEAN THE FILTER
27. MISSING FILTER - PLACE A CLEAN FILTER
28. BLOCKED OR CLOGGED FAN - DISASSEMBLE AND CHECK THE FANS
29. DEFECT FAN CABLE - REPLACEMENT BY THE INSTALLER
30. DEFECT FAN - REPLACEMENT BY THE INSTALLER
THE RED LED LIGHT
OF THE FIRE MODE
IS ON 31. THE MOBILE AIR FLAP IS
BLOCKED - CHECK THAT THE FLAP IS MOBILE
THE LED BUTTON
IS RED, CONTROL
PANEL IS GREEN 32. OTHER ERROR ON MAINBOARD - CHECK THE WIRING AND THERMOCOUPLE
VENTILATION DOES
NOT WORK
WITHOUT AN
ERROR BEING
REPORTED 33. THE THERMOCOUPLE SENSOR IS
DEFECT - CHECK THE SENSOR
34. THE DOOR SWITCH IS BADLY
ADJUSTED - ADJUST THE DOOR SWITCH BRACKET