24
The position of the cursor has therefore an impact on the thermal output of the appliance, and
over the time between two successive reloads.
Safety
In case of a power failure, the fans and the combustion management system can no longer
regulate and limit the temperature of the appliance.
This can pose a risk for the appliance and the cladding. In such a case, the safety function of the
Easy system automatically closes the air distribution flap. There is therefore no more primary air
supply, and this limits the power of the appliance as well as the risk of overheating.
Note that the stove can still be used in that situation. It will be supplied exclusively with
secondary air, and will therefore have a reduced output.
(!) In the case of powerless operation, limit the wood supply to the minimum load. See limits in
the table below. Under no circumstances must wood be loaded above the level of the
secondary air holes.
As a general rule, it is essential to observe the following operating instructions set out in this
manual in order to:
- guarantee safety of the installation and the home;
- guarantee optimal combustion and limit emissions;
- guarantee cleanliness and longevity of the appliance.
During the operation of the stove:
- The temperature of the accessible parts of the appliance can cause burns, even in the absence
of flames. Do not leave unsupervised children close to the stove.
- Avoid placing objects in the radiation zone (within a radius of one metre from the glass pane).
- Never obstruct the ventilation grates of the cladding.
- In the event of a chimney fire, immediately close the door and adjust the fire to a minimum.
Ash pan
This appliance is equipped with an ash pan made of 2 parts. The lower part of the ash pan forms
a bowl which collects all ashes that may fall next to the ash pan itself. It can also be used as a lid
for the ash pan to prevent ashes from falling out during transport. Finally, it limits the
temperature at the bottom of the appliance by creating an air gap between the ash pan and the
heating element.
When the ash pan is put back in place, check that the door closes properly.
