Steel frame Table form lift TL 1512
213300043
81
8.3.3 Please note! Entering the ground station (2-m area)
CAUTION!
When approaching the ground station, the
platform stops 2 m above the ground.
Subsequently, the material can only be transported
in dead man’s mode via the pendant control panel
at the ground station. (see Chapter Fig. 45, 59,
page )
Prior to continuing the downward motion,
ensure all personnel remains outside of this
area underneath the platform.
Only continue if you are sure there is no
personnel underneath the platform.
After 3 seconds the platform can continue
to travel into the ground station.
Travel can only continue in dead man’s mode.
8.3.4 Switch to personnel transport.
Switching to personnel transport after the platform has
stopped
If the platform stops at a floor or at the ground station after
a material transport, the platform must be entered and the
load position gate, the hinged ramp and the platform gate
must be closed and locked.
Subsequently, the platform control system can be used to
operate the platform.
As soon as pressing a button of the platform control
system, the platform is automatically placed in personnel
transport mode and can only be controlled in dead man's
mode from the platform.
Changing to transport of personnel while material is being
transported
As soon as pressing a button of the platform control
system while the platform is in motion, the control system
switches immediately to personnel transport mode.
At this time, it is only possible to move the platform in the
dead man’s mode.
