EN
40
3.8
Relocating the bed
When moving the bed to a different location, please follow the safety instructions below:
–
Lower the mattress support frame to the lowest position.
–
Before moving the bed, pull out the wall plug and attach it to the frame with the
hanger to prevent the power cord from falling down and being run over. Ensure
that the cord does not drag on the ground.
–
Before reinserting the wall plug, visually inspect the power cord for any signs of
mechanical damage (kinks or pinched areas, abrasions or exposed wires).
–
Run the cable in such a way that it cannot be pulled, run over or be damaged by
moving parts of the nursing care bed; then put the plug back into the socket.
3.9
Transport, storage and operating conditions
Transport and storage
Operation
Temperature
0°C to +40°C
10°C to +40°C
Relative humidity
20% to 80%
20% to 70%
Atmospheric pressure
800hPa to 1060hPA
3.10
Usage notes
To keep the nursing care bed in a particular location, the brakes
on the bed frame casters must be locked. To do this, push the
locking lever on the lower frame downward with your foot.
When needed, the integrated side rails must be pulled
up until they click into position. When using mattresses
of different thicknesses, a minimum distance of 22 cm
must be maintained between the top edge of the side
rail and the mattress without compression; otherwise, a
third top-mounted rail should be used.
