EN
14
The height of the nursing care bed can be adjusted either via two height-adjustable actu-
ators or through a base frame equipped with a single or dual drive system. The outer sur-
face of the tubular steel frame is stove-enamelled with a PES powder coating.
Side rails
Each nursing care bed can be equipped with two side rails on each side at a specific safety
height. The side rails can be raised and lowered along a track. Impact absorbers ensure
quiet slider operation, and the ends are fitted with functional end caps. An ergonomically
shaped release button allows for easy adjustment of the side rails.
2.1
Adjusting the continuous side rail
The release button for adjusting
the continuous side rails is lo-
cated just above the upper side
rail in the sliding track.
To lower the side rails, hold the
groove in the upper side rail, lift
the side rail slightly, and press
the release button on either the
headboard or footboard. The
side rail is then released on that
side and can be easily lowered to
the end of the track. The side rail
is now in a diagonal position. To
lower the other side, perform
these steps again at the opposite
end of the bed. The side rail is
now in its lowered position.
Bock Safety Note
Always lift the side rail slightly before pressing the release button! Failure to do so will damage
the release mechanism.
