Design and function
Select welding task
28
099-000143-BOC01
16.11.2009
5.7.1
Save welding tasks (JOBs)
All user settings are saved immediately after being modified or changed. No special save command or
user input is needed.
The last welding parameters that were used are available even after switching off and on again.
There are altogether 8 JOBs that can be used to save the respective parameters for different frequently
occurring welding tasks. JOB 0 is set by default on delivery and every time the machine control is reset.
The control display shows the currently selected JOB number for approx. 2 seconds after the machine is
switched on. You change JOBs by pressing the "Switch display/JOB number" button until the respective
signal lamp lights. You can choose between 8 JOBs (JOB 0 to 7) with the welding parameter rotary dial.
The parameters for the currently selected JOB can now be set according to the welding task.
You cannot switch JOB numbers during welding.
NOTE
Note the differences between JOB 0 and JOBs 1 to 7:
The parameter values for AC frequency, AC balance and Tungsten electrode
diameter/optimisation of ignition are set with the respective rotary dials in JOB 0. In JOBs 1 to 7,
this setting takes place in the function sequence (signal lights with the same names show the
selection).
5.7.1.1
Displaying and changing the JOB number
Operating
element
Action Result
n x
Select JOB display
Change the JOB number
1 x
If the display switchover is pressed or if there is no keyboard input for 5
seconds, the new JOB will be active
