BOB’S SPACE RACERS®
WATER BLAST
TM
(LINKABLE) ARCADE
17
19. SLIDE PUMP ASSEMBLY BACK INTO POSSITION AND REINSTALL COIN BOX ASSEMBLY WHEN PUMP
SERVICE IS COMPLETED.
3-3-2. Glass Cleaning:
1. Clean the inside of the glass with a plastic scrub pad to remove dirt and sediment from the glass. DO NOT use any
steel wool or scotch bright pads as these will damage the plastic side glass panels.
NOTE: IF THE GLASS IS BADLY STAINED, USE C.L.R. MINERAL REMOVAL. SPRAY FIRST TO GET RID OF
TOUGH MINERAL DESPOSITS.
2. Spray RAIN-X on the inside of the glass to help prevent minerals from forming on the glass.
3. Clean the outside of the glass with any good commercial glass cleaner.
3-3-3. Draining the Water:
1. Set the game's GAME / DRAIN valve to the drain position.
2. Press the PROGRAM button on the game's programming panel to
access the programming options.
3. Press the OPTION button and advance to the DRAIN option.
4. Press the VALUE button to turn the pump on and off.
NOTE: THE PUMP IS RUN ON A GROUND FAULT INTERRUPTER
CIRCUIT. THIS IS TO PROVIDE A HIGH DEGREE OF SAFETY TO
THE CUSTOMER. IF THE PUMP DOES NOT RUN WHEN THE GAME
IS STARTED, CHECK THE RESET BUTTON ON THE GROUND
FAULT OUTLET ON. THE RESET BUTTON MUST BE DEPRESSED
DURING GAME PLAY TO BE ACTIVATED. PUSHING THE RESET
BUTTON WHEN THE GAME IS OVER WILL NOT HAVE ANY
EFFECT.
5. Hold the drain hose into the 5 gallon pail and press the VALUE button to start the pump.
6. Run the pump until ALL of the water empties out of the tank. Turn off the pump.
7. Turn the GAME / DRAIN valve to the GAME position.
8. Remove the screen at the bottom of the tank and clean both the tank and the screen. Re-install the screen.
3-3-4. Filling the Water Tank:
1. Add 5 gallons of water to a bucket and add 1 TBSP. Cascade Dishwashing powder. (This will help keep the glass
clean). DO NOT use too much Cascade or foaming will result.
SUGGESTION: ALTHOUGH ANY WATER CAN BE USED, USE DISTILLED WATER WHENEVER POSSIBLE.
DISTILLED WATER HAS ALL OF THE MINERALS REMOVED AND WILL DRASTICALLY EXTEND THE TIME
INTERVAL BETWEEN WATER CHANGES.
2. Clean the inside of the glass with a plastic scrub pad to remove dirt and sediment from the glass.
NOTE: IF THE GLASS IS BADLY STAINED, USE C.L.R. MINERAL REMOVAL SPRAY FIRST TO GET RID OF
TOUGH MINERAL DEPOSITS.
Summary of Contents for WATER BLAST LINKABLE
