Bob's Space Racers WATER BLAST LINKABLE, Operation Manual

Page: 21 / 39

BOB’S SPACE RACERS® WATER BLAST
TM
(LINKABLE) ARCADE
21
5. Re-install the new sensor using the other sensor as a guide to proper
positioning. (See image to the right)
6. Check for proper alignment between the magnetic sensor and the
magnet that is located on the target arm.
7. Re-install the target pan.
8. Play a couple of games to check for proper operation.
9. Re-install the lower rear access door.
3-3-9. Main P.C. Board Removal and Installation:
ALTHOUGH THE MAIN P.C. BOARD CAN BE REMOVED THROUGH THE FRONT DOOR WITH THE SEAT AND
CASH BOX ENCLOSURE IN PLACE, IT IS MUCH EASIER TO DO SO IF THEY ARE REMOVED FIRST. TO
REMOVE THEM FOLLOW THE INSTRUCTIONS BELOW.
WARNING: BE SURE TO UNPLUG THE GAME BEFORE SERVICING TO AVOID SERIOUS INJURY OR DAMAGE
TO THE GAME.
1. Open the front doors of the game and remove the bolts that hold the seat base to the game.
2. Move the seat assembly out of the way.
3. Remove the cash box and remove the single bolt located in the bottom
of the cash box enclosure.
4. Slide the cash box enclosure out of the game and unplug the
programming panel connector. Set the cash box enclosure to the side.
5. Unplug all of the connectors from the Main P.C. Board.
(See image to the right)
6. Unscrew the retaining clamp on the board mounting bracket and remove
the board.
7. Install a new P.C. Board, making sure that the board engages the slots
on the bottom of the mounting bracket.
8. Tighten the P.C. Board retaining clamp.
NOTE: BE SURE THE CLAMP IS NOT CONTACTING ANY COMPONENTS ON THE BOARD OR SERIOUS
DAMAGE MAY RESULT.
9. Re-install all of the connectors. Be sure they are inserted properly and that all of the connector locks are snapped
into place.
NOTE: BEFORE CLOSING THE UNIT YOU WILL NEED TO REPROGRAM THE BOARDS IF THEY WERE
LINKED TO OTHER GAMES. SEE THE PROGRAMMING SECTIONS FOR INSTRUCTIONS ON “REPROGRAM
LINKING GAMES”
10. Re-install the cash box.
11. Re-install the seat assembly.