BOB’S SPACE RACERS®
WATER BLAST
TM
(LINKABLE) ARCADE
12
1.
Unplug all the networking cables running from each board to another. (They are the cables that resemble phone
cables)
2.
Go to the main control board (the board for players 1 and 2). Enter the programming mode by pressing the
PROGRAMMING button. (The first black button on programming panel to the left)
PROGRAMMING
PANEL
STEP Button
SELECT Button
PROGRAMMING Button
3.
After entering the programming mode, press the SELECT button (The center black button on the programming
panel) until the first two front displays read “Reset Defaults”.
4.
Once the first two front displays read “Reset Defaults” press the STEP button until the corresponding displays
read a 1 at the bottom.
5.
To lock in the change to the settings press the SELECT button and then to exit the programming mode press
the PROGRAM button.
6.
Proceed to the next control board and follow the exact steps for that board starting at step #2 above, and
proceed through to step #5. (Continue in this fashion for the remainder of the boards.)
(
REPROGRAMMING THE BOARDS)
7.
Once all stations have been reset, reconnect all of the phone cables to each board. The cables must be
plugged into P11 or P12 phone jacks.
P11 & P12 PHONE JACKS
Summary of Contents for WATER BLAST LINKABLE
