Bob's Space Racers WATER BLAST LINKABLE, Operation Manual

Page: 22 / 39

BOB’S SPACE RACERS® WATER BLAST
TM
(LINKABLE) ARCADE
22
3-3-10. Display P.C. Board Removal and Installation:
ALTHOUGH THE CONNECTORS FOR THE DISPLAY P.C. BOARD CAN BE REMOVED THROUGH THE FRONT
DOOR WITH THE SEAT AND CASH BOX ENCLOSURE IN PLACE, IT IS MUCH EASIER TO DO SO IF THEY ARE
REMOVED FIRST. TO REMOVE THEM FOLLOW THE INSTRUCTIONS BELOW.
WARNING: BE SURE TO UNPLUG THE GAME
BEFORE SERVICING
TO AVOID SERIOUS INJURY OR DAMAGE TO THE GAME.
1. Open the front doors of the game and remove the bolt that holds the
seat base to the game.
2. Move the seat assembly out of the way.
3. Remove the cash box and remove the single bolt located in the bottom
of the cash box enclosure. (See image to the right)
4. Slide the cash box enclosure out of the game and unplug the
programming panel connector. Set the cash box enclosure to the side.
5. Unplug the Appropriate harness from the Main P.C. Board. If it is the left
hand display, unplug connector
P6 from the Main board. If it is the Right
hand display, unplug P7 .
NOTE: WHEN DISCONNECTING THE RIGHT HAND DISPLAY
CONNECTOR (P7), BE SURE TO UNPLUG THE SINGLE WIRE FAST-
ON CONNECTOR THAT IS RIGHT AT THE CONNECTOR AS WELL.
6. Remove the upper and lower rear access panels to be able to access
the display harnessing. (See image to the right)
NOTE: THE DISPLAY HOUSING AND HARNESSING ARE REMOVED
AND INSTALLED AS A SUB-ASSEMBLY.
7. Pull the display harness to the rear of the game and up through the
cabinet holes.
8. Unbolt the display housing from the rear of the cabinet and pull straight
out of the game.
9. Assemble in reverse order
.
3-3-11. Display P.C. Board Servicing
1. Slide the display filter (Plexiglass cover) out of the housing.
2. Remove the 8 bolts that hold the Display mounting bracket to the Display housing.
(See image to the right)
3. Slide the mounting bracket out of the housing.
4. Remove the connectors and defective display P.C. Board.
5. Assemble in reverse
order.