BMW K 1600 GTL, Rider'S Manual

Page: 74 / 176

Confirmation tone sounds
twice (if programmed).
Anti-theft alarm is activated.
To deactivate the motion sen-
sor (for example if you are
about to transport the motor-
cycle on a train and the sway-
ing movement of the moving
train could trip the alarm), press
button
1 on the remote con-
trol again during the activation
phase.
Turn signals are illuminated
three times.
Confirmation tone sounds three
times (if programmed).
Motion sensor is deactivated.
Alarm
with anti-theft alarm OE
The alarm can be triggered by
the motion sensor
an attempt to use an unau-
thorized key to switch on the
ignition
disconnecting the alarm system
from the motorcycle battery
(alarm system battery takes
over the power supply - alarm
sound only, no illumination of
the turn signals)
All functions are sustained even if
the internal battery of the anti-
theft alarm system is flat; the
only difference is that an alarm
cannot be triggered if the system
is disconnected from the motor-
cycle's battery.
An alarm lasts for approximately
26 seconds. During the alarm, an
alarm tone sounds and the turn
signals flash. The type of alarm
sound can be programmed.
with central locking
OE
You can cancel an alarm at any
time without deactivating the
anti-theft alarm by pressing but-
ton
2 on the remote control.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
4
72
z Operation