BMW 318D, Owner'S Handbook Manual

Page: 349 / 430

4. Make sure that the correct tyre settings, see
page
347 , have been made.
5. Switch on drive-ready state but do not drive
off.
6. Reset the tyre inflation pressure: "Perform
reset".
7. Drive off.
The wheels are shown grey and the following ap‐
pears on the display: "Resetting Tyre Pressure
Monitor…".
After driving for several minutes, the set tyre in‐
flation pressures are accepted as the specified
tyre inflation pressures. The reset is completed
automatically during the journey.
If the reset was successful, the wheels are
shown in green on the Control Display and the
following appears: "Tyre Pressure Monitor active.
See label for recommended pressures.".
You can interrupt your journey at any time. The
reset resumes automatically when you continue
your journey.
Messages: for tyres without
special approval
General
Dynamic Stability Control DSC will be activated if
necessary as soon as a message for low tyre in‐
flation pressure appears.
Safety note
WARNING
A damaged standard tyre with too little or no
tyre inflation pressure impairs driving character‐
istics, for example steering and braking. Tyres
with run-flat properties allow a limited level of
stability to be maintained. There is a risk of ac‐
cident. Do not continue driving if the vehicle is
fitted with normal tyres. Comply with the notes
on run-flat tyres and continuing to drive with
these tyres.
If a tyre inflation pressure check is
required
Message
A symbol with a Check Control message is
shown on the Control Display.
Symbol Possible cause
The tyre was not inflated properly,
for example insufficient air was
added or there was a natural, even
loss of tyre inflation pressure.
Measure
Check the tyre inflation pressure and adjust as
necessary.
If the tyre inflation pressure is
insufficient
Message
A yellow warning lamp is illuminated in
the instrument cluster.
In addition, a symbol with a Check Control mes‐
sage is shown on the Control Display.
Symbol Possible cause
There has been a loss of tyre infla‐
tion pressure.
Measure
1. Reduce speed. Do not exceed a speed of
130 km/h, 80 mph.
2. At the next opportunity, for example at a filling
station, check the tyre inflation pressure in all
four tyres and correct if necessary.
Seite 349
Wheels and tyres
MOBILITY
349
Online Edition for Part no. xxx - VI/19